After a couple hours of work, I managed to drill some holes through my rebound board that were offset from the original 4 holes. I used the template that's floating around this forum, however I recommend that those new holes be pushed further out from the center. When using the template I found I had to end up boring out the hole a bit larger because it was too far inwards.
Mounted the rebound board back up to the platform and then drilled into the frame with a 1/4" cobalt tip drill bit. Put my bolts in, washers and nuts and the unit is now more secure than ever!
I also added a 50lb sandbag as most commonly recommended. I've also gotten a size 7 bag to help out a newbie like me.
Image:
Mounted the rebound board back up to the platform and then drilled into the frame with a 1/4" cobalt tip drill bit. Put my bolts in, washers and nuts and the unit is now more secure than ever!
I also added a 50lb sandbag as most commonly recommended. I've also gotten a size 7 bag to help out a newbie like me.
Image:
Comment